What should we pay attention to when operation of paddy sheller machine?
Category: Blog
The paddy sheller's hulling rate can up to 99%, equivalent to two of the rubber roll huller shelling two times the effect.The body is sealed type, chaff dust full in a bag inside, the door or inside the room without dust, environmental protection and health. Then,what should we pay attention to when operating the paddy sheller machine? Here are five points.
1. Please check the machine before use, we should under the hopper installation, check all parts of the screw fastening machine to complete, good, no indoor hulling odd monsters, base and ground to be flat. After confirmation of the normal power supply, the machine idling for 5 minutes, no abnormal noise, violent warming, strong vibration can be ready for material processing.
1. Please check the machine before use, we should under the hopper installation, check all parts of the screw fastening machine to complete, good, no indoor hulling odd monsters, base and ground to be flat. After confirmation of the normal power supply, the machine idling for 5 minutes, no abnormal noise, violent warming, strong vibration can be ready for material processing.
2. When the machine is in normal operation, we should slowly pull into the feeding plate, gradually increase the machine load, to be normal meters, then carefully adjusted to meet the requirements of quality. When using, please don't leave the machine, don't let the children close to or operate, the person leave, please power off.
3. If the machine stops halfway, the feed inlet should be closed first, and then the rice mill will be milled and shut down.
4. When the machine starts to work, we need to view and from the rice outlet, such as a large proportion of the shell not clean, can adjust the hand wheel shelling on the device to the direction of the small screw slowly until it reaches the peeling effect, if found rice stripping out of a certain proportion is broken is shifted to the major hand wheel the direction of regulation, expand the gap milling rollers.
5. It is strictly forbidden to clean the main engine with water, so as to prevent the water from falling on the fuselage, so as to avoid electric leakage.
4. When the machine starts to work, we need to view and from the rice outlet, such as a large proportion of the shell not clean, can adjust the hand wheel shelling on the device to the direction of the small screw slowly until it reaches the peeling effect, if found rice stripping out of a certain proportion is broken is shifted to the major hand wheel the direction of regulation, expand the gap milling rollers.
5. It is strictly forbidden to clean the main engine with water, so as to prevent the water from falling on the fuselage, so as to avoid electric leakage.
